Re: [CAD_CAM_EDM_DRO] Tachometer Kits are In!
Posted by
Ward M.
on 2000-04-11 21:14:10 UTC
Dan,
This tach kit looks really good. A person could use the dual sensor on a
single motor to monitor two different rings of reflective material. One
ring could have four marks and the other two so that the accuracy for both
high and low RPMs would be good.
Ward M.
ward@...
This tach kit looks really good. A person could use the dual sensor on a
single motor to monitor two different rings of reflective material. One
ring could have four marks and the other two so that the accuracy for both
high and low RPMs would be good.
Ward M.
ward@...
----- Original Message -----
From: "Dan Mauch" <dmauch@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, April 11, 2000 7:18 AM
Subject: Re: [CAD_CAM_EDM_DRO] Tachometer Kits are In!
For those interested in a low cost tachometer for mills/ drills/ lathes you
may want to check out the pictures and the narrative for the new tachometer
kits that I have. See www.seanet.com/~dmauch
------------------------------------------------------------------------
Get paid for the stuff you know!
Get answers for the stuff you don't. And get $10 to spend on the site!
http://click.egroups.com/1/2200/2/_/423600/_/955462666/
------------------------------------------------------------------------
Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
To Unsubscribe, read archives, change to or from digest.
Go to: http://www.onelist.com/isregistered.cgi
Log on, and you will go to Member Center, and you can make changes there.
For the FAQ, go to http://www.ktmarketing.com/faq.html
bill,
List Manager