CAD CAM EDM DRO - Yahoo Group Archive

Re: Gecko power supply transformer

on 2004-02-20 06:55:14 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "plastiguy" <plastiguy@a...>
wrote:
> OK folks, thanks for all of your timely and technically helpful
> pointers on my Gecko G320 drivers power supply. I've settled a few
> things already based on some of the insight and suggestions
provided
> from my first set of questions. But, I forgot one.
> When sizing my toroidal transformer to go from nominally 120 VAC
> (concede it can be 112 to 125 sporadically)into 36 VAC to the
filter
> caps and the bridge rectifier, am I to spec a volt-amp rating, and
> which volts and amp numbers do I use and how do I use them?
> thanks a lot in advance
> Scott

If I can add to the question......

I've recently ran across some references to rating for a center tap
vs. end to end of a 3 secondary wire transformer.

Dave

Discussion Thread

plastiguy 2004-02-19 23:39:15 UTC Gecko power supply transformer turbulatordude 2004-02-20 06:55:14 UTC Re: Gecko power supply transformer caudlet 2004-02-20 07:34:18 UTC Re: Gecko power supply transformer Jon Elson 2004-02-20 09:09:40 UTC Re: [CAD_CAM_EDM_DRO] Gecko power supply transformer Jon Elson 2004-02-20 09:16:02 UTC Re: [CAD_CAM_EDM_DRO] Re: Gecko power supply transformer