Parts list
Posted by
Lee Leathers
on 2004-02-26 12:42:31 UTC
Alright, Now that I got the motors/xylotex/computer/monitor, where should I
be looking for for parts to build the cnc other than what I have... I just
want a 2axis model (up and down). I want the dist from left to right to be
24inch max. and up and down should be around 4 inchs.
Lets say this will be holding a pencil (but in actualluality it will be
holding a metal cylinder 2 inches deep, 8 or 9 inchs wide and 2 inchs from
top to bottom).
I want a reputable website to buy these from. As I probably will be building
a lot of these.
Also, my dad has a metal fabrication plant with a "Laser", heh, so I can
machine anything out of metal :)
My other 2 requirements are that it is accurate up to .001inchs ( is that
avg? or good/bad?), and I would like it to be very inexpensive...
thanks ---Lee
be looking for for parts to build the cnc other than what I have... I just
want a 2axis model (up and down). I want the dist from left to right to be
24inch max. and up and down should be around 4 inchs.
Lets say this will be holding a pencil (but in actualluality it will be
holding a metal cylinder 2 inches deep, 8 or 9 inchs wide and 2 inchs from
top to bottom).
I want a reputable website to buy these from. As I probably will be building
a lot of these.
Also, my dad has a metal fabrication plant with a "Laser", heh, so I can
machine anything out of metal :)
My other 2 requirements are that it is accurate up to .001inchs ( is that
avg? or good/bad?), and I would like it to be very inexpensive...
thanks ---Lee