CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Yet more DRO

Posted by Tim Barnard
on 2000-04-13 12:58:33 UTC
Just remember you can't make a jig bore out of a knee mill with a dro. 1
micron is really pushing the envelope.

Tim Barnard

-----Original Message-----
From: Paul Corner [mailto:Paul.Corner@...]
Sent: Thursday, April 13, 2000 11:39 AM
To: CAD_CAM_EDM_DRO@egroups.com
Subject: Re: [CAD_CAM_EDM_DRO] Yet more DRO



Time for the nomex suit. - I was under the impression that 10 microns was a
yardstick. That aside, surely the higher the resolution of the scales, the
closer you can get in terms of machining tolerance ?
My mill will work down to 5 microns, yet overall accuracy is more like 20
microns. If I move to 1 micron scales at a reasonable cost, then a 5 micron
tolerance should be attainable.
When laser inferometers become affordable, then we can move to sub micron
accuracies :-}

Regards, Paul.

> Getting a bit picky aren't we?
>
> I'll settle for the 10 microns, back when I was a kid We used a
yardstick...
> Marc

------------------------------------------------------------------------
Get paid for the stuff you know!
Get answers for the stuff you don’t. And get $10 to spend on the site!
http://click.egroups.com/1/2200/2/_/423600/_/955655023/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager

Discussion Thread

Paul Corner 2000-04-12 14:30:21 UTC Yet more DRO D.F.S. 2000-04-13 08:02:43 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO Jon Elson 2000-04-13 12:14:51 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO Paul Corner 2000-04-13 12:43:42 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO Tim Barnard 2000-04-13 12:58:33 UTC RE: [CAD_CAM_EDM_DRO] Yet more DRO D.F.S. 2000-04-13 13:01:14 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO ptengin@a... 2000-04-13 13:48:46 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO Paul Corner 2000-04-13 14:38:19 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO Jon Elson 2000-04-13 15:55:20 UTC Re: [CAD_CAM_EDM_DRO] Yet more DRO