Motor Wiring
Posted by
george_barr
on 2004-03-12 00:29:34 UTC
Is there some method to wire my stepper motors to my breakout board?
I am currently using 2 Ethernet Cat5 (8 wire, twisted pair) cable (1
for the Phase A-D for the motors, and another cable for the limit
switches). Is this method safe? What kind of wire should I use, or
can I use any wire?
I am currently using 2 Ethernet Cat5 (8 wire, twisted pair) cable (1
for the Phase A-D for the motors, and another cable for the limit
switches). Is this method safe? What kind of wire should I use, or
can I use any wire?
Discussion Thread
george_barr
2004-03-12 00:29:34 UTC
Motor Wiring
Roy J. Tellason
2004-03-12 06:05:08 UTC
Re: [CAD_CAM_EDM_DRO] Motor Wiring
Robert Campbell
2004-03-12 06:57:14 UTC
Re: [CAD_CAM_EDM_DRO] Motor Wiring