New to CNC, need help finding sources
Posted by
Mike Kunz
on 2004-03-17 18:54:04 UTC
Hi, ALl,
I'm brand to new to CNC. I haven't made my purchase yet of a system. My
Grizzly G1007 is being converted to ball screws per the Jeff Davis plans
this very week. I need help figuring out what to buy along the lines of
software and electronics. I'm after a servo motor system to control 4
axes. I have a 233 MHz Pentium-MMX desk top that can be used to run the
unit. Aside from that, it seems there are so many options and so much
information I available that it makes it difficult to sort out what is and
what isn't important.
Could use some tutelage if someone would be willing. Thanks.
Mike
I'm brand to new to CNC. I haven't made my purchase yet of a system. My
Grizzly G1007 is being converted to ball screws per the Jeff Davis plans
this very week. I need help figuring out what to buy along the lines of
software and electronics. I'm after a servo motor system to control 4
axes. I have a 233 MHz Pentium-MMX desk top that can be used to run the
unit. Aside from that, it seems there are so many options and so much
information I available that it makes it difficult to sort out what is and
what isn't important.
Could use some tutelage if someone would be willing. Thanks.
Mike
Discussion Thread
Mike Kunz
2004-03-17 18:54:04 UTC
New to CNC, need help finding sources
wayne_j_hill
2004-03-17 21:09:01 UTC
Re: New to CNC, need help finding sources
wayne_j_hill
2004-03-17 21:47:29 UTC
Re: New to CNC, need help finding sources