CAD CAM EDM DRO - Yahoo Group Archive

Re: Problem with a Gecko 340

Posted by tig415
on 2004-05-01 16:59:54 UTC
> >
> Does it still work in closed loop mode, ie. the motor resists
being turned
> manually when the drive is enabled?
Hi Jon

yes. instead of faulting and shutting down the drive it looses power
momentarily then reengages. My X axis screws are connected with a
belt. if I grab the belt and give it a tug it normally faults the
drive. Now it just goes clunk clunk clunk as the drive cuts in and
out.

Derek

Discussion Thread

tig415 2004-05-01 10:14:23 UTC Problem with a Gecko 340 Jon Elson 2004-05-01 11:49:55 UTC Re: [CAD_CAM_EDM_DRO] Problem with a Gecko 340 Roy J. Tellason 2004-05-01 12:02:44 UTC Re: [CAD_CAM_EDM_DRO] Problem with a Gecko 340 tig415 2004-05-01 16:59:54 UTC Re: Problem with a Gecko 340 Vince Negrete 2004-05-01 17:07:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Problem with a Gecko 340