Re: Could it be this easy?
Posted by
Monte
on 2004-05-15 08:16:07 UTC
It sounds like you would need a drawing program that can save the file
as a dxf file and run the dxf file through a post processor to get a
g-code part program to run your router. There are some free to cheap
dxf/g-code programs out there that I've seen. I don't have any names
for you though.
Monte
as a dxf file and run the dxf file through a post processor to get a
g-code part program to run your router. There are some free to cheap
dxf/g-code programs out there that I've seen. I don't have any names
for you though.
Monte
Discussion Thread
testfly@a...
2004-05-14 21:33:29 UTC
Re: [CAD_CAM_EDM_DRO] Could it be this easy?
Greg Pettengill
2004-05-15 04:11:05 UTC
Re: [CAD_CAM_EDM_DRO] Could it be this easy?
Monte
2004-05-15 08:16:07 UTC
Re: Could it be this easy?
Bob McKnight
2004-05-15 14:07:25 UTC
Re: [CAD_CAM_EDM_DRO] Could it be this easy?
steve
2004-05-15 20:57:43 UTC
Re: [CAD_CAM_EDM_DRO] Could it be this easy?
ballendo
2004-05-16 05:54:12 UTC
Re: Could it be this easy? (Yes.)
Nick Ibbitson
2004-05-16 08:30:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: Could it be this easy? (Yes.)
washcomp
2004-05-16 08:47:25 UTC
Re: Could it be this easy? (Yes.)
caudlet
2004-05-16 10:26:47 UTC
Re: Could it be this easy?
Nick Ibbitson
2004-05-16 10:52:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Could it be this easy? (Yes.)
Fred Smith
2004-05-16 21:59:27 UTC
Re: Could it be this easy? (Yes.)
D. Daniel McGlothin
2004-05-16 21:59:33 UTC
Re: [CAD_CAM_EDM_DRO] Could it be this easy?
rainnea
2004-05-16 22:23:04 UTC
Re: Could it be this easy? (Yes.)
Nick Ibbitson
2004-05-17 02:09:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Could it be this easy? (Yes.)
Nick Ibbitson
2004-05-17 02:29:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Could it be this easy? (Yes.)