Re: [CAD_CAM_EDM_DRO] Re: Safety -- servo vs. stepper

Jon mentioned the Servo-To-Go ISA PC board

What does the Servo-To-Go card attempt at replacing taking into
consideration that
generally:

Servos are driven by say geckos or like
and the geckos are driven by a breakout board connected to your parallel
port under the control of EMC or MACH2.

The picture I have in my head is that Servo_To-Go would replace the Parallel
Port? Is this correct?

Assuming it is does Mach2 or EMC know how to talk to Servo-To-Go?


Regards
Jess

----- Original Message -----
From: "Jon Elson" <elson@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Saturday, May 22, 2004 1:47 AM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Safety -- servo vs. stepper


>
>
> Leslie M. Watts wrote:
>
> >What I hope a discussion like this generates is really an
> >informal FMEA (failure mode effects analysis).
.....snip



--
Outgoing mail is certified Virus Free.
Checked by AVG Anti-Virus (http://www.grisoft.com).
Version: 7.0.245 / Virus Database: 262.10.3 - Release Date: 21/5/2004