Re: [CAD_CAM_EDM_DRO] Re: parallel port

Thanks for all the replys. I have tried all of the software you'll have
mentioned :) and it seems like I just have to play around with each program
for a bit until I can read/write to the I/O of the parallel port, then I can
read/write fine until I restart my computer... Then have to playaround with
it again
Oh well,

Anyone mess with IO OCX? And would like to send me examples of their code
with it.. The manual isn't much of a manual :)

thanks!-Lee

----- Original Message -----
From: "Raymond Heckert" <jnr@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, May 20, 2004 8:20 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: parallel port


> As an aside... Check out page 88 of the latest issue of EDN (Electronics
> Design News, I think)... Anyways, they show how to use the parallel port
to
> directly program a 96-series EPROM chip (maybe it was a 93-series?)
>
> RayHex
>
> ----------
> > From: campgems <Don@...>
> >
> <snip>
> > Have you tried hooking a printer up and see if it works?
> >
> > The reset state of your LPT port may vary by dirver. I don't now
> > this to be a fact, but it is worth considering. If a known good
> > printer works, with the proper drivers installed, your port is OK.
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... davemucha@...
[Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
> Yahoo! Groups Links
>
>
>
>
>
>