Re: [CAD_CAM_EDM_DRO] M98 SubProgram
Posted by
Yesamazza@a...
on 2004-07-17 14:35:43 UTC
In a message dated 7/17/2004 12:26:17 PM US Mountain Standard Time,
titanium@... writes:
different to G92 try using a simple sub routine with one coordinate call and see if
it completes the sub and returns correctly. An error further in the program
can stop it on a line were there is no problem so don't rule out the problem
being lines below the line that the machine stops.
[Non-text portions of this message have been removed]
titanium@... writes:
> I seem to be having some difficulty with subPrograms. Specifically,You may be having trouble with the G92 some machine controllers react
> I can call them, but when the program reaches the M99 line, it
> stops, it does not return to the line after the M98. Any Ideas?
different to G92 try using a simple sub routine with one coordinate call and see if
it completes the sub and returns correctly. An error further in the program
can stop it on a line were there is no problem so don't rule out the problem
being lines below the line that the machine stops.
[Non-text portions of this message have been removed]
Discussion Thread
omencues
2004-07-17 11:51:29 UTC
M98 SubProgram
Statman Designs, LLC
2004-07-17 12:19:49 UTC
Re: [CAD_CAM_EDM_DRO] M98 SubProgram
Yesamazza@a...
2004-07-17 14:35:43 UTC
Re: [CAD_CAM_EDM_DRO] M98 SubProgram