Re: [CAD_CAM_EDM_DRO] Motor Question(cross posted)
Posted by
tomp_tag@i...
on 2004-07-20 19:48:50 UTC
To see if the wires are 2 for motor and 2 for tacho:
spin the motor by hand , each pair will output a dc voltage
if the guess is true. if two are heavier gauge, then they're the
motor. Try to note the pairs and polarities. If you have a known
motor and can run it at 1000 rpm, it could spin the unknown motor
shaft and you could find the V/1Krpm of the tacho.
tomp
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
spin the motor by hand , each pair will output a dc voltage
if the guess is true. if two are heavier gauge, then they're the
motor. Try to note the pairs and polarities. If you have a known
motor and can run it at 1000 rpm, it could spin the unknown motor
shaft and you could find the V/1Krpm of the tacho.
tomp
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
Discussion Thread
metlmunchr
2004-07-20 09:00:48 UTC
Motor Question(cross posted)
Les Newell
2004-07-20 09:20:54 UTC
Re: [CAD_CAM_EDM_DRO] Motor Question(cross posted)
Jon Elson
2004-07-20 17:33:25 UTC
Re: [CAD_CAM_EDM_DRO] Motor Question(cross posted)
tomp_tag@i...
2004-07-20 19:48:50 UTC
Re: [CAD_CAM_EDM_DRO] Motor Question(cross posted)
andyolney
2004-07-26 12:39:51 UTC
Re: Motor Question(cross posted)