Re: [CAD_CAM_EDM_DRO] General Stepper Motor Specs Question ??????
Posted by
Ron K
on 2004-07-21 19:16:48 UTC
NOPE ! if only it were that easy , the type of magnets and the
construction of the motor have allot to do with it's power .
Russ Waters wrote:
Ron Kline
American Precision Ceramics
construction of the motor have allot to do with it's power .
Russ Waters wrote:
>Hi all... been some time now that I had a subject for this group........ It's about stepper motor specs and how they relate to HOLDING TORQUE.--
>
>I have found in my own research wheather or not to purchase steppers on ebay, that the voltage , amps and resistance seem to be related to the holding torque or how powerful the stepper is in torque oz./inches.
>
>Example.. a stepper (size 23) that I recently found specs on was rated 3volts @ 3amps, which by ohms law gave it a resistance of only 1 ohm. The "holding torque" was a good 185 ~ 265 oz./inches, depending on how it was wired. So back to my question, can one assume with simular specs, there would be a simular holding torque for other steppers?
>
>Thanks in advance,
>Russ
>
>
>
>
Ron Kline
American Precision Ceramics
Discussion Thread
Russ Waters
2004-07-21 14:54:29 UTC
General Stepper Motor Specs Question ??????
Ron K
2004-07-21 19:16:48 UTC
Re: [CAD_CAM_EDM_DRO] General Stepper Motor Specs Question ??????
Tad Johnson
2004-07-22 11:24:29 UTC
Wireless RS-232 and Parallel signals?
Roy J. Tellason
2004-07-22 11:47:21 UTC
Re: [CAD_CAM_EDM_DRO] Wireless RS-232 and Parallel signals?
Mariss Freimanis
2004-07-23 12:32:13 UTC
Re: General Stepper Motor Specs Question ??????
Russ Waters
2004-07-23 15:31:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: General Stepper Motor Specs Question ??????
Mariss Freimanis
2004-07-23 19:18:35 UTC
Re: General Stepper Motor Specs Question ??????