CAD CAM EDM DRO - Yahoo Group Archive

Re: Ballscrew with machined ends, were to purchase?????

Posted by rllalonde2000
on 2004-08-09 18:09:17 UTC
--Russ, check out homeshopcnc.com for Thomson ballscrews and give the
end dimensions you need for a quote.

Rick L.

- In CAD_CAM_EDM_DRO@yahoogroups.com, Russ Waters <mycncworld@y...>
wrote:
> Hi group.... awhile back this subjects came up, and I am not sure
if there were any conclusions on were one could buy a leadscrew and
get the ends machine at a reasonable cost....
>
>
> I am looking to buy a Thompson or compatable .631" ballscrew with
a .2" lead @ approx. total lenght of 26" with both ends machined....
Any help with this is greatly appreciated.
>
> Russ
>
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> [Non-text portions of this message have been removed]

Discussion Thread

Russ Waters 2004-08-09 10:51:04 UTC Ballscrew with machined ends, were to purchase????? carlos_is_dead 2004-08-09 16:49:15 UTC Re: Ballscrew with machined ends, were to purchase????? JanRwl@A... 2004-08-09 17:12:26 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew with machined ends, were to purchase????? rllalonde2000 2004-08-09 18:09:17 UTC Re: Ballscrew with machined ends, were to purchase????? Russ Waters 2004-08-10 12:04:45 UTC Re: [CAD_CAM_EDM_DRO] Re: Ballscrew with machined ends, were to purchase?????