Re: [CAD_CAM_EDM_DRO] help needed for modal and nonmodal g codes..

In a message dated 8/11/2004 2:21:01 PM Eastern Daylight Time,
mushilove4all@... writes:

Brad Eyben <abeyben@...> wrote:
I believe that can be set in your post processor. If you contact your
Mastercam dealer I'm sure they can quickly alter your post.
Brad



I know MasterCam can correct that problem. It is just a matter of
correcting the post processor so it puts the G code on each line.

Randy Abernathy
4626 Old Stilesboro Road NW
Acworth, GA 30101-4066
Phone / Fax: 770-974-5295
Cell: 678-772-4113
E-mail: Cnc002@...

I furnish technical support, repair, and other related services for your
industrial woodworking machinery. My background as Senior Service Engineer for
the SCMI Group for nearly fifteen years with factory training, combines with
my extensive background in electronics, mechanics, pneumatics, electrical and
CNC machinery to offer you needed support for your machinery.


[Non-text portions of this message have been removed]