Re: [CAD_CAM_EDM_DRO] sherline spindle for machine?
Posted by
Tom Hubin
on 2004-08-29 21:36:13 UTC
Hello Rick,
their motor. Some of the folks that use small bits use this setup. So it
does not seem unreasonable for you to run the spindle at 4000rpm.
Tom Hubin
thubin@...
> This motor can spin atSherline sells a pulley set for their spindle to run at 10krpm with
> 8000 rpm, so I was thinking of using a 2:1 reduction to a my sherline
> head. Would 4000 rpm on the sherline head be pushing things, or is
> that acceptable?
their motor. Some of the folks that use small bits use this setup. So it
does not seem unreasonable for you to run the spindle at 4000rpm.
Tom Hubin
thubin@...
Discussion Thread
skykotech
2004-08-28 16:02:49 UTC
sherline spindle for machine?
Tom Hubin
2004-08-29 21:36:13 UTC
Re: [CAD_CAM_EDM_DRO] sherline spindle for machine?