Re: Nuts and Volts

Thanks there are two more. When I have the last article which I just sent
off yesterday published I will post all of them at my web site. Together the
4 artciles should help the newbies quite a bit.
The limit and home switch connectors as you stated correct were on the 2 amp
board. They are not on the 5 amp board per say but I have a board that I
call the db25 junction board that
does. It really make connection the PC to the 5 amp drivers as easy as
pugging in 3 cables. It has just about every status and controlled line
connected to a output pin so that you cam work with any software that uses
the parallel port for home, limit and solid state relays.
Dan
-----Original Message-----
From: WAnliker@... <WAnliker@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, June 11, 1999 1:17 PM
Subject: [CAD_CAM_EDM_DRO] Nuts and Volts

>From: WAnliker@...
>
>I just received my June issue of Nuts and Volts today, and Dans article is
>excellent.
>
>
>Dan, a question for you, will the hookups for the limit switches, and the
>home switches as shown in the schematic also work with your 5 amp driver
>board?
>bill
>list manager
>
>------------------------------------------------------------------------
>What do lizards and rock music have in common?
>http://www.onelist.com
>They both have communities at ONElist. Find yours today!
>------------------------------------------------------------------------
>welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe:
> http://www.onelist.com/unsubscribe/CAD_CAM_EDM_DRO
>bill, List Manager
>