FS Bridgeport Boss 5 and Heidenhain TNC-145 control
Posted by
gtrz240
on 2004-09-04 14:48:50 UTC
I have a Bridgeport Boss 5 CNC stripped of the old factory Boss CNC
controls and ready for retro fit. I also have a Heidenhain TNC-145 3-
axis CNC control unit that is complete. The Heidenhain control has
servo's, mag tape reader and all the manuals. The Heidenhain come off
another bridgeport Boss 5 machine.
The Bridgeport has some wear on the Y axis but the screws are tight
and the table is clean. I will sell the Bridgeport for $795 and the
Heidenhain for $895. of both for $1495. Located in Portland, Or.
zgoo@... or cell 503-572-3845
Thanks-Dan
P.S. I don't have any of the old Boss parts that where removed
controls and ready for retro fit. I also have a Heidenhain TNC-145 3-
axis CNC control unit that is complete. The Heidenhain control has
servo's, mag tape reader and all the manuals. The Heidenhain come off
another bridgeport Boss 5 machine.
The Bridgeport has some wear on the Y axis but the screws are tight
and the table is clean. I will sell the Bridgeport for $795 and the
Heidenhain for $895. of both for $1495. Located in Portland, Or.
zgoo@... or cell 503-572-3845
Thanks-Dan
P.S. I don't have any of the old Boss parts that where removed