Re: [CAD_CAM_EDM_DRO] Digest Number 482
Posted by
David Forsyth
on 2000-05-07 04:53:44 UTC
On 7 May 00 at 7:05, CAD_CAM_EDM_DRO@egroups.com wrote masterfully:
I'm in for some programming too, I'm working now in Delphi, but I'll
be downloading the tcl stuff and will learn it for the purposes
if needed.... I'll be building a small mill in the next six months so
will have a testbed too. That will mainly run Linux/EMC, but the
machine will have removable harddrives so I can swap it to Win95 if
needed.
I have an option on some small servo motors with encoders. just two
though. is it possible to run EMC with 2 servos and one stepper?
steam and wind
--
David Forsyth
Keeper of the listserver for South African Railways fans _|_ His
Part time gricer, kiter, photographer, father etc etc | Way
http://www.ru.ac.za/departments/iwr/staff/daf/welcome.html | Up
> Message: 7yes, stay here
> Date: Sat, 6 May 2000 13:22:13 EDT
> From: wanliker@...
> Subject: Re: Conversational Programming and NAMES- very long!
>
>
> In a message dated 5/3/0 3:52:58 PM, ginger@...
> writes:
>
> << QUESTION
> Should we carry on this discussion here on this list or start a new
> list devoted to CPNC? Remember, this is going to need to get into a
> lot of detail if we are going to really develop a good package, and
> we are going to have to exchange large files and screen shots.
> >>
>
> I personally would like to see it stay on this list. I liked what I
> saw of your program while at NAMES, I will be home by the end of
> this week, and hope to get some good time in the shop playing with
> the CPNP program then. I lucked into some ball end mills, so have
> figured out what I need to do to the Sherline Mill for my first
> conversion. bill
I'm in for some programming too, I'm working now in Delphi, but I'll
be downloading the tcl stuff and will learn it for the purposes
if needed.... I'll be building a small mill in the next six months so
will have a testbed too. That will mainly run Linux/EMC, but the
machine will have removable harddrives so I can swap it to Win95 if
needed.
I have an option on some small servo motors with encoders. just two
though. is it possible to run EMC with 2 servos and one stepper?
steam and wind
--
David Forsyth
Keeper of the listserver for South African Railways fans _|_ His
Part time gricer, kiter, photographer, father etc etc | Way
http://www.ru.ac.za/departments/iwr/staff/daf/welcome.html | Up
Discussion Thread
David Forsyth
2000-05-07 04:53:44 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 482
Andrew Werby
2000-05-08 14:51:45 UTC
Re: [CAD_CAM_EDM_DRO] Digest Number 482