Re: DIY CMM ??
Posted by
Jeff Rossel
on 2000-05-07 08:41:38 UTC
I am also building a DRO setup(for my & X 10 mini lathe). I am
wondering if anyone has programed Tom's DRO in visual basic. I am not
even sure if it is possable in VB. I would like to make a GUI spcific
to my lathe. Settings for the toolpost angle, postion for the saddle
and crosslides. The ability to enter the as cut size, desired
size....etc.
Any help out there?
Thanks Jeff
wondering if anyone has programed Tom's DRO in visual basic. I am not
even sure if it is possable in VB. I would like to make a GUI spcific
to my lathe. Settings for the toolpost angle, postion for the saddle
and crosslides. The ability to enter the as cut size, desired
size....etc.
Any help out there?
Thanks Jeff
> I'm also in the planning stages of building a 4-axis DRO onmy 3-in-1
> using the board kit from Camtronics, so if I could some howuse the
> same computer andmuch ?
> modified software that would be great. Am I asking for too
>
>
>
> Thanks,
> Mike Mueller
> Antioch, CA
Discussion Thread
Mike Mueller
2000-05-05 10:31:22 UTC
DIY CMM ??
Ray Henry
2000-05-06 05:16:38 UTC
Re: DIY CMM ??
Jeff Rossel
2000-05-07 08:41:38 UTC
Re: DIY CMM ??