Re: pcb manufacturing
Posted by
Ted Walls
on 2004-09-16 13:57:03 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, <lanebarr@b...> wrote:
think it is in the ULP link. Unzip the files to your UPL folder
(usually program files>eagle-4.11>ulp).
check the readme.txt file which gives instructions on how to use the
program and how to configure it to your needs.
I have found this to be a better program than outlines as it will
remove the majority of the small slivers that outlines can leave.
It also produces files for the drilling, but beware you will have to
edit out several lines to get them to run if you are using Mach2. I
think the program was written for turbocnc. If you get stuck contact
me off list and I will email you the files and a copy of an edited
drill file.
Hope this helps
> I have assembled a 3 axis pcb mill...Go to cadsoft site http://cadsoft.de and download pcb-gcode.zip I
think it is in the ULP link. Unzip the files to your UPL folder
(usually program files>eagle-4.11>ulp).
check the readme.txt file which gives instructions on how to use the
program and how to configure it to your needs.
I have found this to be a better program than outlines as it will
remove the majority of the small slivers that outlines can leave.
It also produces files for the drilling, but beware you will have to
edit out several lines to get them to run if you are using Mach2. I
think the program was written for turbocnc. If you get stuck contact
me off list and I will email you the files and a copy of an edited
drill file.
Hope this helps
Discussion Thread
lanebarr@b...
2004-09-16 13:01:51 UTC
pcb manufacturing
Ted Walls
2004-09-16 13:57:03 UTC
Re: pcb manufacturing
Harvey White
2004-09-16 14:14:33 UTC
Re: [CAD_CAM_EDM_DRO] pcb manufacturing