Re: [CAD_CAM_EDM_DRO] eg &g torque systems servo card manual

Hi Steve

+/15V control - Are you sure ???
Most analogue amps use +/10V control voltage. If it is a typo, then the Copley
422 amp will probably work (assuming it is 15A peak).

Regards, Paul.

On Thursday 30 September 2004 13:53, steve wrote:
> any suggestions
> for a possible replacement drive? 15amp, tach feed back servo motors,
> 100vdc bus power, +15/0/-15 control voltage., d/a i think is 5v.? any
> help is greatly appreciated.

--
irc channel for EMC users at irc.freenode.org
/join #emc

Pieces of seven! Pieces of seven! (Hrm, parroty error)