I am going to cnc my rotary table and looking for ideas
Posted by
A. G. Eckstein
on 2004-10-19 13:50:38 UTC
Hey gang,
I have a Phase II rotary table, a spare servo, spare gecko, so why not?
Does anybody have any good ideas on how to go about the physical
arrangement? I sure would hate to do it and then find a site where someone
has already done it better!!
Any thoughts or pointers to sites of someone who has done it will be
appreciated.
Thanks in advance.
Bubba
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust
LaGrange, GA
http://bellsouthpwp.net/A/r/Arts_home_page/cnc/
[Non-text portions of this message have been removed]
I have a Phase II rotary table, a spare servo, spare gecko, so why not?
Does anybody have any good ideas on how to go about the physical
arrangement? I sure would hate to do it and then find a site where someone
has already done it better!!
Any thoughts or pointers to sites of someone who has done it will be
appreciated.
Thanks in advance.
Bubba
OLDER THAN DIRT
Country Bubba
(Actually the inventor of Country and Bubba)
In God We Trust
LaGrange, GA
http://bellsouthpwp.net/A/r/Arts_home_page/cnc/
[Non-text portions of this message have been removed]