Rutex relay board crashes system
Posted by
Derek
on 2004-11-05 14:29:39 UTC
Hi
I just developed a problem in that when I turn on my spindle through Mach2 it causes the computer to go to blue screen with the word" Problem with hardware call vendor" or something like that. It does it even with the VFD off. Thats what leads me to believe its the relay board. Is it possible that its the parallel port freaking out?
I know this is a tough one to advise on but I thought Id throw it out there before I ordered another board.
Thanks
Derek
I just developed a problem in that when I turn on my spindle through Mach2 it causes the computer to go to blue screen with the word" Problem with hardware call vendor" or something like that. It does it even with the VFD off. Thats what leads me to believe its the relay board. Is it possible that its the parallel port freaking out?
I know this is a tough one to advise on but I thought Id throw it out there before I ordered another board.
Thanks
Derek
Discussion Thread
Derek
2004-11-05 14:29:39 UTC
Rutex relay board crashes system
washcomp
2004-11-05 14:43:54 UTC
Re: Rutex relay board crashes system