Newbie with mill question
Posted by
John II
on 2004-11-11 20:50:09 UTC
I'm new to this forum, and have been enjoying it for several weeks now. I joined because I'm trying to learn how to build my own cnc router bridge mill from scratch. And I am learning thanks to everyone on the forum.
This is my first posting... I want my mill to have fine tolerances, and I think a little chatter outside of the forms prime purpose should have a minute amount of tolerance as well ; )
It would be nice at the end of each tagged posting, if there were references to where the other cnc forums can be found, so that each posting could be more "on topic" But as I said... while every one discusses which stepper driver routinely burns out, it's nice to hear a mild diversion on occasion. It's like a little fresh air.
[Non-text portions of this message have been removed]
This is my first posting... I want my mill to have fine tolerances, and I think a little chatter outside of the forms prime purpose should have a minute amount of tolerance as well ; )
It would be nice at the end of each tagged posting, if there were references to where the other cnc forums can be found, so that each posting could be more "on topic" But as I said... while every one discusses which stepper driver routinely burns out, it's nice to hear a mild diversion on occasion. It's like a little fresh air.
[Non-text portions of this message have been removed]