working great now! Bridgeport, Mach2, Geckos
Posted by
Keith Clark
on 2004-11-21 19:05:46 UTC
After dropping the rapid speeds and lowering the pulse rate of
Mach2, my Bridgeport is running great with no stalling and no
heating of the Geckos. It is incredible how powerful and complete
Mach2 is. Having control of the spindle direction, home positions,
fixture offsets, the ability to do tapping and helical threading
just to name a few of the many improvements I am lucky to have. It
is amazing how inexpensive Mach2 is.
Many had faith in the Geckos and they were correct to point me away
from the drives as the source of my problems. My stepper motors are
smooth and powerful. The Campbell breakout board is great with
isolation and protection built in - a very inexpensive but excellent
product as well
Mariss had suggested that I would get quieter and smoother
performance with the microstepper drive. It is amazing how bright
and shiny the surfaces are now using the same bits and parameters as
I used to use with the original Boss 6 controller. The old machine
stalled when the weather was cold, and I never saw such mirror
finishes as I do now.
Thanks for all the help. We will see if the current configuration
holds up over the long term. So far so good.
Keith Clark
Mach2, my Bridgeport is running great with no stalling and no
heating of the Geckos. It is incredible how powerful and complete
Mach2 is. Having control of the spindle direction, home positions,
fixture offsets, the ability to do tapping and helical threading
just to name a few of the many improvements I am lucky to have. It
is amazing how inexpensive Mach2 is.
Many had faith in the Geckos and they were correct to point me away
from the drives as the source of my problems. My stepper motors are
smooth and powerful. The Campbell breakout board is great with
isolation and protection built in - a very inexpensive but excellent
product as well
Mariss had suggested that I would get quieter and smoother
performance with the microstepper drive. It is amazing how bright
and shiny the surfaces are now using the same bits and parameters as
I used to use with the original Boss 6 controller. The old machine
stalled when the weather was cold, and I never saw such mirror
finishes as I do now.
Thanks for all the help. We will see if the current configuration
holds up over the long term. So far so good.
Keith Clark
Discussion Thread
Keith Clark
2004-11-21 19:05:46 UTC
working great now! Bridgeport, Mach2, Geckos
JamesCullins
2004-11-21 19:30:50 UTC
Re: [CAD_CAM_EDM_DRO] working great now! Bridgeport, Mach2, Geckos
R Rogers
2004-11-21 22:22:21 UTC
Re: [CAD_CAM_EDM_DRO] working great now! Bridgeport, Mach2, Geckos
Keith Clark
2004-11-22 05:23:07 UTC
now Probes? Re: working great now! Bridgeport, Mach2, Geckos