CAD CAM EDM DRO - Yahoo Group Archive

Re: EDM questions

on 2004-12-14 16:39:04 UTC
It sounds like the big pops are the correct mode of operation rather
than the spot welding. You want to reduce the amount of energy per
spark so perhaps a smaller capacitor for this electrode.

Not much help on the other matter other than a glorified screwdriver
method.

Graham

Discussion Thread

Mark Stacey 2004-12-14 15:20:20 UTC EDM questions Graham Stabler 2004-12-14 16:39:04 UTC Re: EDM questions turbulatordude 2004-12-14 17:23:59 UTC Re: EDM questions Larry Wright 2004-12-14 20:04:42 UTC Re: [CAD_CAM_EDM_DRO] EDM questions Jon Elson 2004-12-15 09:06:08 UTC Re: [CAD_CAM_EDM_DRO] EDM questions turbulatordude 2004-12-15 10:56:35 UTC Re: EDM questions Mark Stacey 2004-12-15 12:56:04 UTC Re: EDM questions Richard 2004-12-15 18:07:23 UTC Re: EDM questions turbulatordude 2004-12-16 08:38:13 UTC Re: EDM questions turbulatordude 2004-12-16 08:44:56 UTC Re: EDM questions turbulatordude 2004-12-16 08:49:15 UTC Re: EDM questions - Jon's circuit edm_specialists 2005-04-28 12:40:07 UTC EDM questions