Re: EDM questions
Posted by
turbulatordude
on 2004-12-14 17:23:59 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
be drained.
Dave
wrote:
>rather
> It sounds like the big pops are the correct mode of operation
> than the spot welding. You want to reduce the amount of energy perscrewdriver
> spark so perhaps a smaller capacitor for this electrode.
>
> Not much help on the other matter other than a glorified
> method.Just feed the unit into the work. only a few pops and the cap will
>
> Graham
be drained.
Dave
Discussion Thread
Mark Stacey
2004-12-14 15:20:20 UTC
EDM questions
Graham Stabler
2004-12-14 16:39:04 UTC
Re: EDM questions
turbulatordude
2004-12-14 17:23:59 UTC
Re: EDM questions
Larry Wright
2004-12-14 20:04:42 UTC
Re: [CAD_CAM_EDM_DRO] EDM questions
Jon Elson
2004-12-15 09:06:08 UTC
Re: [CAD_CAM_EDM_DRO] EDM questions
turbulatordude
2004-12-15 10:56:35 UTC
Re: EDM questions
Mark Stacey
2004-12-15 12:56:04 UTC
Re: EDM questions
Richard
2004-12-15 18:07:23 UTC
Re: EDM questions
turbulatordude
2004-12-16 08:38:13 UTC
Re: EDM questions
turbulatordude
2004-12-16 08:44:56 UTC
Re: EDM questions
turbulatordude
2004-12-16 08:49:15 UTC
Re: EDM questions - Jon's circuit
edm_specialists
2005-04-28 12:40:07 UTC
EDM questions