Re: Needing help with Denford.....

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "endurorider334"
<estavish@b...> wrote:

>
>
> Hello all,
>
> I just got a Denford Micromill and I would like to change the

boards

> out to Gecko or Xylotex. Has anyone done this before and does
> anyone have a wiring diagram to do it or input on which driver to
> use? I dont have too much experience with elctronics so please

bare

> with me. Thanks ERIC

Hi Denfords can be difficult as there dosent seem to be much
information around. If your experience with electronics is limited
you are probabally best to go for a complete retrofit using Gecko
and say Mach 2. I have a starturn (lathe) and managed to use the
original drivers with Mach2 but its been a long and twisted path.
Fred