Newbie - G COde question
Posted by
dacostad@y...
on 2000-05-24 05:18:33 UTC
I have just converted my Sherline lathe to CNC (Progressive Logic)
and have be learning G Code.
I need some advice from the experts.
I have a 3/4" round aluminium which I wish to round the end on. As
the maximum acceptable cut on the Sherline is about 0.02" I obviously
need to take several passes at cutting the curve.
Can anybody give me a clue as to how the G- Code should look?
Thanks
David Da Costa
and have be learning G Code.
I need some advice from the experts.
I have a 3/4" round aluminium which I wish to round the end on. As
the maximum acceptable cut on the Sherline is about 0.02" I obviously
need to take several passes at cutting the curve.
Can anybody give me a clue as to how the G- Code should look?
Thanks
David Da Costa