Re: [CAD_CAM_EDM_DRO] Indexer LPT software

Here is a copy of an e-mail from Hoyt, in regards to Indexer front -end
he sells. I think the last time he was on this group, he got dis-enchanted
and quit participating.

Steve

*************************

Hi Steve:

Am following up on your note, hope this finds you well! I've been busy
lately professionally and personally but have had time to continue
development of the software. It has been much more thoroughly debugged, has
added power, easier implementation of peripherals, limit and safety
switches, and improved UI. An example of new feature is easy polar or 2/3
axis profile digitizing. This is covered more fully on the BelFab site.
Custom routines still available. G-code version, CNCv200G, has been revised
to put turning routines in XZ format. I'll be happy to send you a manual
and demo of CNCv239 if you like. Have a good one.

Regards,
*************************