Re: [CAD_CAM_EDM_DRO] Fw: motor ?

Bruce Pigeon wrote:

>
>
>-------Original Message-------
>
>From: Bruce Pigeon
>Date: 02/09/05 13:33:31
>To: DIY-CNC@...
>Subject: motor ?
>
>
>Hi
>
>I know machining and am learning programing cnc.
>What I know very little about is electronics.
>
>I was digging through some of the motors that I acquired over the years. I
>found what I think could become a spindle motor. I have not been able to
>find anything from the manufacturer.
>
>The motor was made by Kollmorgan Copr. or Inland Motor. Both of their
>names are on the tag.
>The motor is a model TTE-2953-1011-v-35
>Serial # 84G81-2043
> DC volts Motor amps LB-FT
>cont(stall) 11.3 15.8 6
>Peak(stall) 55.1 90.0 30
>Maximum RPM 2000
>DC tach volts/1000rpm 32.5
>
>This is all of the information from the tag on the motor. Does anyone know
>what I have. It is big and it is heavy. How would I go about testing it
>before trying to build it into something.
>
>

Hmm, these ratings are confusing. If the max continuous rating is 11 V
at 15.8 A,
that is only 179 W. Not a lot. but, I guess that voltage is just at
stall, so we can
figure resistance from that, 0.715 Ohms. That sounds nice and low.

Testing? Connect it to a DC supply and see if it spins!

Jon