[CAD-CAM-EDM-DRO]Emco Mayer mills
Posted by
Chris Paine
on 2000-05-30 16:28:28 UTC
I work for a small firm in the UK. they have just bought out another small
firm so the boss can retire, Among the machines that arrived are small Emco
mills, I think the no.300 is on one I cant remember the model numbers but
the tools are around a turret mounted vertically (top facing) these are
stepper motor machines. I have been told they often blow a driver board when
switched on and I have one to see If I can do anything, It has 10 BUZ73 's
along the edge for one axis, does this make sense to anyone? can you have 5
phase steppers? anyway a .3 ohm R had gone pop and a small fet behind it
(probably the buz 73 infront of the resistor first?) anyone Know about these
machines ie. common problems or solutions?
Chris Paine East Grinstead UK
chris@...
firm so the boss can retire, Among the machines that arrived are small Emco
mills, I think the no.300 is on one I cant remember the model numbers but
the tools are around a turret mounted vertically (top facing) these are
stepper motor machines. I have been told they often blow a driver board when
switched on and I have one to see If I can do anything, It has 10 BUZ73 's
along the edge for one axis, does this make sense to anyone? can you have 5
phase steppers? anyway a .3 ohm R had gone pop and a small fet behind it
(probably the buz 73 infront of the resistor first?) anyone Know about these
machines ie. common problems or solutions?
Chris Paine East Grinstead UK
chris@...