Re: Which CAD/CAM is best for 2D Plasma Cutting??

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Andre Mann" <andre@d...>
wrote:

> Have a look at Dolphin PartMaster
>
>> ----- Original Message -----
> From: "bertmantx" <bertmantx@y...>

> Subject: [CAD_CAM_EDM_DRO] Which CAD/CAM is best for 2D Plasma

Cutting??

>
>
> >

Thanks for the information this looks like a very good product line.
But I was hoping to spend a little less money on startup. I will keep
the address in favorites.

PS Can you tell me if the dolphin line will run direct from parallel
port (25pin) or do you have to have post processor?? Running direct
for now but thinking of getting some kind of post proc.