gecko g201
Posted by
Ms Kimberly Knight
on 2005-02-16 16:12:35 UTC
what does it mean when the gecko drive outputs on both channels show
the chop frequency (normal) and only one shows the current
modulation waveform? both windings check out resistively. and
ofcourse the motor wont rotate and holding torque is zilch.
what does all this mean????
Kim
the chop frequency (normal) and only one shows the current
modulation waveform? both windings check out resistively. and
ofcourse the motor wont rotate and holding torque is zilch.
what does all this mean????
Kim