CAD CAM EDM DRO - Yahoo Group Archive

Re: Stand alone cnc controller

Posted by doug98105
on 2005-03-01 09:03:28 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "John Stevenson" <john@s...>
wrote:
>
> If it's for commercial use have a look at
>
> http://www.divisionmaster.com
>
> This can run anything from small stepper up to large servo driven
axis.
>
> John S.

Any one know what these cost in "real" money, like delivered to USA
in dollars?

Doug

Discussion Thread

smeboss 2005-02-28 16:32:10 UTC Stand alone cnc controller Stephen Wille Padnos 2005-02-28 17:03:44 UTC Re: [CAD_CAM_EDM_DRO] Stand alone cnc controller smeboss 2005-02-28 17:17:33 UTC Re: Stand alone cnc controller Robert Campbell 2005-02-28 17:23:50 UTC Re: [CAD_CAM_EDM_DRO] Stand alone cnc controller turbulatordude 2005-02-28 19:31:11 UTC Re: Stand alone cnc controller Steve Stallings 2005-02-28 20:31:17 UTC Re: Stand alone cnc controller Tony Jeffree 2005-02-28 23:03:52 UTC Re: [CAD_CAM_EDM_DRO] Stand alone cnc controller John Stevenson 2005-03-01 01:12:59 UTC Re: Stand alone cnc controller Bill Nelson 2005-03-01 05:39:12 UTC Re: [CAD_CAM_EDM_DRO] Stand alone cnc controller doug98105 2005-03-01 09:03:28 UTC Re: Stand alone cnc controller Alan Marconett 2005-03-01 10:23:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Stand alone cnc controller Tony Jeffree 2005-03-01 10:28:08 UTC Re: [CAD_CAM_EDM_DRO] Re: Stand alone cnc controller smeboss 2005-03-04 05:19:15 UTC Re: Stand alone cnc controller