Re: Allen Bradley NC Controller
Posted by
dshulbert7
on 2005-03-17 09:19:48 UTC
Thanks to everyone that took the time to reply!. I do have the
manual, but can't locate it just now. Took a look at the device
yesterday, this is what it is:
On the front panel:Allen-Bradley Fastrak 4000 Motion Controller
On the inside of the cabinet on the back side of the front panel(a
data plate): Tri-Sgma Corp., S/N:40401, Model: 21809402
A paper tag attached to a lead of the large transformer inside the
cabinet: Summit, Dana and the statement; This stepping motor driver
has been factory set as follows: the only lines filled out
were "Total Current" 4 amps & at the bottom the date 11-03-83
Best Regards, Doug
manual, but can't locate it just now. Took a look at the device
yesterday, this is what it is:
On the front panel:Allen-Bradley Fastrak 4000 Motion Controller
On the inside of the cabinet on the back side of the front panel(a
data plate): Tri-Sgma Corp., S/N:40401, Model: 21809402
A paper tag attached to a lead of the large transformer inside the
cabinet: Summit, Dana and the statement; This stepping motor driver
has been factory set as follows: the only lines filled out
were "Total Current" 4 amps & at the bottom the date 11-03-83
Best Regards, Doug
Discussion Thread
dshulbert7
2005-03-15 10:49:10 UTC
Allen Bradley NC Controller
metlmunchr
2005-03-15 13:05:01 UTC
Re: Allen Bradley NC Controller
Bob Muse
2005-03-15 14:00:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: Allen Bradley NC Controller
lcdpublishing
2005-03-15 14:05:04 UTC
Re: Allen Bradley NC Controller
Jon Elson
2005-03-15 19:24:08 UTC
Re: [CAD_CAM_EDM_DRO] Allen Bradley NC Controller
dshulbert7
2005-03-17 09:19:48 UTC
Re: Allen Bradley NC Controller