Using MACH2 with Older Taig CNC MicroMill 2000
Posted by
Wally Blackburn
on 2005-03-26 09:50:01 UTC
I'm watching a Taig CNC mill on eBay and I'm curious about how hard it
would be to ditch the DOS-based software that comes with it and use
something like MACH2.
Any wisdom out there?
Thanks,
Wally
would be to ditch the DOS-based software that comes with it and use
something like MACH2.
Any wisdom out there?
Thanks,
Wally
Discussion Thread
Wally Blackburn
2005-03-26 09:50:01 UTC
Using MACH2 with Older Taig CNC MicroMill 2000
Andrew Werby
2005-03-27 11:32:16 UTC
Re: Using MACH2 with Older Taig CNC MicroMill 2000