Power supply for my servos
Posted by
mataf01
on 2005-03-26 16:06:51 UTC
Hi everybody,
This is the correction of my previous post where I had
written "Alim "instead of Power supply (sorry for this mistake I'm
Belgian and french spoken)
Here is my problem:
I'm planning to by 3 DC brushed servo motors.
They are rated 120 V 4 Amps continuous and 20Amps peek Im planning to
use them with Geko Drives. They will then work a little underpowered
at 80V (max of Geko drives).
What are your suggestions about the minimum requested power supply to
power them 3 without problems?
Thanks
Patrick
This is the correction of my previous post where I had
written "Alim "instead of Power supply (sorry for this mistake I'm
Belgian and french spoken)
Here is my problem:
I'm planning to by 3 DC brushed servo motors.
They are rated 120 V 4 Amps continuous and 20Amps peek Im planning to
use them with Geko Drives. They will then work a little underpowered
at 80V (max of Geko drives).
What are your suggestions about the minimum requested power supply to
power them 3 without problems?
Thanks
Patrick