Need Pin numbers for Camtronics Control Board.
Posted by
Bill Blackburn
on 2005-03-31 22:27:26 UTC
Hi Guys
This is a little off topic so please bare with me. I am trying to
connect a Camtronics, 3 Axis, 2 Amp Controller Board to the Parallel
Port of my Computer and the problem I am having is trying to figure out
which pins to use at the connector of the Controller Board?
The Camtronics Controller Board has a 25 pin connector the same as a
Parallel Port. Which Pins (Need Pin numbers) do I use for the three
Direction circuits, the three Signal circuits and the one Ground circuit
to connect to the Parallel Port of my Computer?
Also what signal does the Camtronics Controller Board require for the
Direction and Signal circuits to work properly? Positive or Negative?
Hopefully someone who has one of these Camtronics Boards could check
theirs to get this information for me. I would appreciate it.
Regards
Bill
This is a little off topic so please bare with me. I am trying to
connect a Camtronics, 3 Axis, 2 Amp Controller Board to the Parallel
Port of my Computer and the problem I am having is trying to figure out
which pins to use at the connector of the Controller Board?
The Camtronics Controller Board has a 25 pin connector the same as a
Parallel Port. Which Pins (Need Pin numbers) do I use for the three
Direction circuits, the three Signal circuits and the one Ground circuit
to connect to the Parallel Port of my Computer?
Also what signal does the Camtronics Controller Board require for the
Direction and Signal circuits to work properly? Positive or Negative?
Hopefully someone who has one of these Camtronics Boards could check
theirs to get this information for me. I would appreciate it.
Regards
Bill