Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE
Posted by
Carey L. Culpepper
on 2000-06-13 11:25:10 UTC
Stan: 15 3/4" end to end on a original equipment taper attachment cross
slide. Carey
smcdonal wrote:
slide. Carey
smcdonal wrote:
> Has anyone here adapted something to make a taper attachmet for a[Non-text portions of this message have been removed]
> southbend 9" lathe?
>
> Can someone give me the overall lenth of the cross-slide. The rest I
> can
> figure out.
>
> Thanks
> Stan
>
> -----------------------------------------------------------------------
>
> -----------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Discussion Thread
Carey L. Culpepper
2000-06-13 11:25:10 UTC
Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE
smcdonal
2000-06-13 13:56:26 UTC
Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE