Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE
Posted by
smcdonal
on 2000-06-13 13:56:26 UTC
Carey L. Culpepper wrote:
How wide is the rail itself( the part that you move to make the taper)?
How long is the rail?
How long is the taper attachment itself?
Stan
>How wide is the lower section that the rail sits on?
> Stan: 15 3/4" end to end on a original equipment taper attachment cross
> slide. Carey
>
How wide is the rail itself( the part that you move to make the taper)?
How long is the rail?
How long is the taper attachment itself?
>From this I can figure it out.Thanks
Stan
Discussion Thread
Carey L. Culpepper
2000-06-13 11:25:10 UTC
Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE
smcdonal
2000-06-13 13:56:26 UTC
Re: [CAD_CAM_EDM_DRO] LOOKING FOR PLANS FOR SOUTHBEND TAPER ATTACHMENT FOR 9" LATHE