Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Posted by
Tom Hubin
on 2005-05-31 09:52:45 UTC
Hello Dave,
12.5ipm/sec would require 6 seconds to accelerate from 0 to 75ipm.
Tom Hubin
thubin@...
> Interesting, I go the other way on acceleration for my Taig mill runningI have not checked your figures to calculate acceleration but
> from TurboCNC. I have the acceleration up around 200,000Hz with 1/4
> stepping, 20tpi screws, 1.8deg steppers and a rapid speed of about
> 75ipm, start speed of 0.19ipm (50hz). I think thats about 12.5ipm per
> second acceleration. Rapid speed is reached in 1/10th of a second.
12.5ipm/sec would require 6 seconds to accelerate from 0 to 75ipm.
Tom Hubin
thubin@...
Discussion Thread
ab2pn
2005-05-30 11:24:32 UTC
EMC Acceleration
Jon Elson
2005-05-30 19:59:04 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Tom Hubin
2005-05-31 00:29:19 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Tom Hubin
2005-05-31 01:06:11 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Codesuidae
2005-05-31 09:07:05 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Tom Hubin
2005-05-31 09:52:45 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration
Codesuidae
2005-05-31 11:21:40 UTC
Re: [CAD_CAM_EDM_DRO] EMC Acceleration