RE: [CAD_CAM_EDM_DRO] CNC in Italy - Question

Roland,

220 volt, 50 cycle:

http://www.summerinitaly.com/planning/electricity.asp

I'm sure three phase is available, but I don't know what the standard
plug/receptacle type is for this

Hope this helps,
Jeff

I am building a special CNC machine that will be shipped to Italy for
use in the upcoming Winter Olympics next year -

If there is someone on this group that can advise me authoratively
regarding the electrical service available (Voltage and Hertz)it
would
be appreciated - The Olympics folks don't seem to know the answer -

A reply to the group or direct to me at cardinal.eng@... would
be
appreciated -

Thanks
Roland Friestad