Re: [CAD_CAM_EDM_DRO] T-NUTS

Peter,

I need to get some film developed. I will try and have some more pictures
up this week. I was making good progress until mid April when my brother
died. Since then I have been behind in most of my projects. To finish my
router, I just need to finish wiring my control box and test it out.

Bob Campbell

----- Original Message -----
From: <ptengin@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Saturday, June 17, 2000 9:08 PM
Subject: Re: [CAD_CAM_EDM_DRO] T-NUTS


> In a message dated 06/17/2000 9:06:43 AM Hawaiian Standard Time,
> bob@... writes:
>
> << My current system uses THK rails and
> bearings.
>
> Bob Campbell
> >>
>
> Bob,
>
> Seems the pictures at your website are a bit dated. Got any more
current
> photo's we can look / see? Looks to be a very nice machine!
>
> Peter
> THRD, Inc.
>
> ------------------------------------------------------------------------
> TRAVEL FOR PENNIES ON THE DOLLAR! Get dozens of the best travel agents
> competing for your business with our new FREE service.
> http://click.egroups.com/1/5571/3/_/423600/_/961294096/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager