Re: [CAD_CAM_EDM_DRO] Servo Controller system SYS-3A released
Posted by
Matthew Glenn Shaver
on 2005-09-02 12:38:44 UTC
On Fri, 2005-09-02 at 15:59 +0000, Fred Smith wrote:
something there! ;)
Matt
> The driversWOW! If you could get the voltage up a little bit, you'd really have
> are the DeskCNC SV-500 drivers rated at 5v-30 amps.
something there! ;)
Matt
Discussion Thread
Fred Smith
2005-09-02 09:00:02 UTC
Servo Controller system SYS-3A released
Matthew Glenn Shaver
2005-09-02 12:38:44 UTC
Re: [CAD_CAM_EDM_DRO] Servo Controller system SYS-3A released
Mariss Freimanis
2005-09-02 16:10:24 UTC
Re: Servo Controller system SYS-3A released
Jack
2005-09-02 16:23:28 UTC
Re: Servo Controller system SYS-3A released
Fred Smith
2005-09-03 07:15:46 UTC
Re: Servo Controller system SYS-3A released
Fred Smith
2005-09-03 07:22:55 UTC
Re: Servo Controller system SYS-3A released