CAD CAM EDM DRO - Yahoo Group Archive

Re: Servo Controller system SYS-3A released

on 2005-09-02 16:10:24 UTC
It would also be really cool if the "your price" was less than
the "list price".:-) I think you may have transposed them.

Mariss

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Matthew Glenn Shaver
<mshaver@e...> wrote:
> On Fri, 2005-09-02 at 15:59 +0000, Fred Smith wrote:
>
> > The drivers
> > are the DeskCNC SV-500 drivers rated at 5v-30 amps.
>
> WOW! If you could get the voltage up a little bit, you'd really have
> something there! ;)
>
> Matt

Discussion Thread

Fred Smith 2005-09-02 09:00:02 UTC Servo Controller system SYS-3A released Matthew Glenn Shaver 2005-09-02 12:38:44 UTC Re: [CAD_CAM_EDM_DRO] Servo Controller system SYS-3A released Mariss Freimanis 2005-09-02 16:10:24 UTC Re: Servo Controller system SYS-3A released Jack 2005-09-02 16:23:28 UTC Re: Servo Controller system SYS-3A released Fred Smith 2005-09-03 07:15:46 UTC Re: Servo Controller system SYS-3A released Fred Smith 2005-09-03 07:22:55 UTC Re: Servo Controller system SYS-3A released