Bridgeport R2E4, HELP!!
Posted by
dmedlin1963
on 2005-09-19 02:25:02 UTC
Just bought the mill for $300. The entire control system has been
removed, no electronic or electrical components at all.
The machine is in great condition as far as the table, ball screws,
and ways are concerned.
How much does the thing weigh? (I how to move it form the middle of my
garage to my shop in the backyard)
Can I assemble a Mach 3 stepper control system and add the G-Rex in
the future?
Will a set of Dan Mauch's 1303 oz/in stepper motors move the table if
I use direct drive vs. 2:1 belt mounting?
I have to use a VFD for the 2 hp spindle motor (no 3 phase). I would
like to have Mach 3 control the spindle. Which one should I use?
Daniel T. Medlin
removed, no electronic or electrical components at all.
The machine is in great condition as far as the table, ball screws,
and ways are concerned.
How much does the thing weigh? (I how to move it form the middle of my
garage to my shop in the backyard)
Can I assemble a Mach 3 stepper control system and add the G-Rex in
the future?
Will a set of Dan Mauch's 1303 oz/in stepper motors move the table if
I use direct drive vs. 2:1 belt mounting?
I have to use a VFD for the 2 hp spindle motor (no 3 phase). I would
like to have Mach 3 control the spindle. Which one should I use?
Daniel T. Medlin
Discussion Thread
dmedlin1963
2005-09-19 02:25:02 UTC
Bridgeport R2E4, HELP!!
Mike Delany
2005-09-19 07:39:26 UTC
Re: [CAD_CAM_EDM_DRO] Bridgeport R2E4, HELP!!