Re: [CAD_CAM_EDM_DRO] mach2 question
Posted by
art
on 2005-10-01 06:07:55 UTC
Hi:
Using config/hotkeys you can set any key, but the pageup and down are the
defaults and the most common..
Thanks,
Art
www.artofcnc.ca
Using config/hotkeys you can set any key, but the pageup and down are the
defaults and the most common..
Thanks,
Art
www.artofcnc.ca
----- Original Message -----
From: "Steve Haushahn" <haushahn@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, September 30, 2005 5:11 PM
Subject: Re: [CAD_CAM_EDM_DRO] mach2 question
>I useing page up and page down ,located conveniently close to the arrow
>keys.
> Steven
>
Discussion Thread
urthlite
2004-02-02 07:27:02 UTC
mach2 question
Jon Elson
2004-02-02 10:15:41 UTC
Re: [CAD_CAM_EDM_DRO] mach2 question
Alan Marconett KM6VV
2004-02-02 11:24:45 UTC
Re: [CAD_CAM_EDM_DRO] mach2 question
skykotech
2005-09-30 14:07:23 UTC
mach2 question
Steve Haushahn
2005-09-30 14:29:01 UTC
Re: [CAD_CAM_EDM_DRO] mach2 question
art
2005-10-01 06:07:55 UTC
Re: [CAD_CAM_EDM_DRO] mach2 question