CAD CAM EDM DRO - Yahoo Group Archive

Re: Linear table actuator

on 2005-10-20 13:22:12 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@n...>
wrote:
>
> via google:
>
> http://www.williamsform.com/Threaded_Bars/C-
> 1045_Coil_Threaded_Bar/coil_threaded_bars.html
>
> it is a threaded rod with round bottoms to the grooves, the bars
look
> a little like ballscrews. Nuts are available but are of course just
> like normal nuts. You could probably use a length of the rod to make
> a tap and tap delrin nuts that would be a tight fit as some have done
> with acme bar to avoid the cost of a tap.
>
> Graham
>
Graham, thanks for the link - as you say the thread form does look very
like a ballscrew. What form of nuts did you use yourself?

John.

Discussion Thread

omikse2000 2005-10-19 08:06:04 UTC Linear table actuator majorityuk2000 2005-10-19 08:38:44 UTC Re: Linear table actuator Dhiren Shah 2005-10-19 09:37:48 UTC RE: [CAD_CAM_EDM_DRO] Re: Linear table actuator Graham Stabler 2005-10-20 03:33:08 UTC Re: Linear table actuator majorityuk2000 2005-10-20 13:22:12 UTC Re: Linear table actuator